Buying guide · Updated 19 November 2026

Wood, where the
air allows it.

  • ✓Choose the room first.
  • ✓Ask which timber and finish are meant for a humid room.
  • ✓Buy a ready piece from Celestial Lights if it fits, or have Elor make one to match the joinery.

Choose a wooden chandelier for a Kerala home by the room first, then a timber and finish meant for humid air. Size it to the furniture, keep it clear of the fan, and fix it to the slab, not the false ceiling. Ready pieces are at Celestial Lights. Elor makes custom ones to match the joinery.

A circular wooden chandelier hanging over a living and dining room in a city apartment

Why choose a wooden chandelier?

Because it belongs with the rest of the house. Kerala homes are full of timber: doors, window frames, ceilings, staircases, and in traditional houses whole verandas and courtyards. A wooden chandelier can pick up that joinery instead of competing with it. It gives a warmer, quieter light than crystal, and it reads as part of the architecture rather than an object hung in the middle of the room.

It is a material decision before it is a shape. Choose the room and the timber first, then the design.

Which rooms suit a wooden chandelier?

Rooms where the timber already is. A dining room with a wooden table and a timber ceiling, a living room with wooden joinery, a bedroom with a carved headboard, or a stair with a wooden handrail are natural places. A modern apartment with white walls and gypsum ceilings can also take one, as a single warm object. The living room is covered in chandelier for a living room and the bedroom in bedroom lighting.

Does a wooden chandelier suit a traditional Kerala house?

Often better than crystal does. In a nalukettu or a house built around a central courtyard, a timber piece in the same tone as the rafters or the pillars looks as if it was always there. The care is with the air: a courtyard open to the rain brings damp right into the rooms around it, so ask how the piece is finished for that before choosing it. For a heritage house, keep the light warm and low, so the timber of the room glows rather than the fitting. Colour of light is covered in Kelvin, CRI, and beam.

What should I ask about timber and humidity?

Ask which timber is used, how it is finished, and whether that finish is specified for a humid room. A finish chosen for the room is part of the piece, not a coat added later. Say which room the piece is for, and whether it is near a bathroom, a kitchen, an open window, or a courtyard. Near the coast, ask about the metal parts too: the brackets, chains, and screws, because those are often what show wear first. The coastal guide covers what to ask for near the sea.

AskWhy it matters
Which timber is used?Different woods move differently in humid air.
How is it finished, and is that finish meant for a humid room?A finish chosen for the room is part of the piece, not a coat added later.
Is the room near a bathroom, kitchen, open window or courtyard?Damp air is the risk, not the style of the house.
What metal is used for brackets, chains and screws?Near the coast, the metal parts often show wear first.

If the room is damp for much of the year, compare wood with the alternatives before deciding. Crystal, glass, and sealed metal are the usual ones. The comparison is in crystal, glass, and acrylic and the brass guide.

Close view of a teak chandelier, showing sealed timber slats and joinery

How should a wooden chandelier be lit and switched?

On its own switch, with a dimmer if the fitting and the lamps support one. Many wooden designs throw light through slats, cut-outs, or woven panels, so they draw patterns on the ceiling and walls. Look at the piece lit in a dark room before choosing it, because the shadows are part of the design. Keep the lamps warm, so the timber reads as wood and not as grey. If the piece is the only light in the room, it will be either too bright to look at or too dim to use. The cove and spots carry the room, and the chandelier sits on top. How those layers are set out is in how a lighting plan is built.

What size wooden chandelier do I need?

The same as any chandelier: size it to the furniture and the ceiling, not the whole room. Over a dining table, the piece follows the table. Over seating, it follows the seating group. Timber pieces often look heavier than metal ones of the same size, so when in doubt, go slightly smaller. In a double-height void, the piece is seen from the stair and the upper landing as well as from below, so judge it from above too. The size calculator turns the room into a diameter and a drop.

Can a false ceiling hold a wooden chandelier?

No. A timber frame can be heavier than it looks, and gypsum and POP do not carry a chandelier of any material. The anchor goes into the slab before the ceiling closes. That sequence is in the false-ceiling guide, and how the ceiling and its circuits are laid out is in ceiling and lighting design.

Can a wooden chandelier hang near a ceiling fan?

Not on the same point, and not close. Most Kerala rooms run a fan for much of the year. Give the fan and the chandelier separate points far enough apart that the blades never reach the piece and the moving air does not set it swaying. The layouts are in chandelier with a ceiling fan.

How do I clean a wooden chandelier?

With the power off at the breaker and a dry, soft cloth or brush. Ask the maker what the finish tolerates before using anything else on it, and keep water away from the lamp holders and the wiring. If the piece has glass or crystal parts, those are cleaned as in how to clean a crystal chandelier.

Should a wooden chandelier be ready-made or custom?

Celestial Lights carries ready fittings for every room. If a wooden piece in the collection fits the room, the size, and the climate, it is a shelf fitting. When the span, the timber, or the finish has to match the joinery, send a photograph of the joinery and the measurements, and Elor designs and makes the piece. The process, timeline, and what drives the cost are on custom chandeliers. If the house is still being built, book a lighting consultation and the piece is planned with the rest of the house. See home lighting design.

Shelf, or made for the room?

  • ✓If a wood piece in the collection fits the room and the climate, it is a shelf fitting at Celestial Lights.
  • ✓If the span, the timber, or the finish has to match the joinery, Elor designs and makes it.
  • ✓Custom pieces are usually ready in 3 to 6 weeks. We install custom lights and give installation support for everything else. Warranty is up to 5 years.
  • ✓Kannur and Kozhikode are Celestial Lights stores. The Elor experience centre in Kochi is opening soon.

Want the plan before the piece? Book a consultation. What a custom piece costs is in the pricing guide.

Questions, answered

Is a wooden chandelier suitable in Kerala?

In a dry, air-conditioned room, with a finish specified for humidity, it can be. In open salt air, untreated timber moves and fails. The coastal guide is the check before the material is chosen.

Does a wooden chandelier suit a nalukettu or traditional house?

Often, because it can match the rafters and pillars. Ask how it is finished for damp air if the room opens onto a courtyard, and keep the light warm and low.

Do you have wooden chandeliers on the shelf?

Whatever wood is in the current collection is at Celestial Lights. See the range and we will say what is actually there.

Can you make a wooden piece to match the furniture?

Yes. Send the timber, the span, and a photograph of the joinery. Elor designs and makes that piece, usually in 3 to 6 weeks. We install custom lights and give installation support for everything else.

Does the ceiling hold a timber frame?

The false ceiling does not. The anchor is in the slab, marked before the gypsum closes. Weight is covered in the false-ceiling guide.